wildoats

Wash Down Breaker Amp

4 posts in this topic

I  installed a new Shurflow pro blaster, (4gpm),..It seems to stop after 15-20 seconds when washing the boat at times,  ...It was season end and I didn't troubleshoot it very through,...I'm not sure if The breaker is 10a ?...or it has a different problem going on....thanks !

Share this post


Link to post
Share on other sites

Our R180 has a 6-amp circuit breaker protecting the Raw Water circuit, and the datasheet for your ProBlaster II (PDF) recommends 15-amp protection for the 10-amp max draw of that pump.

You could prove-out the fix, by moving up the 15-amp circuit breaker from the 12-volt receptacle, before spending additional money.

Good luck!

Share this post


Link to post
Share on other sites

Thanks for the input, I'll get back on it this Spring, I did not know the breaker was 6A... thanks  !

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now