Jump to content

Search the Community

Showing results for tags 'color match'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Robalo Boats Forum
    • Fish Talk
    • Boat Talk
    • Dock Talk
    • Newbies
    • Info Center
  • Site Suggestions & Comments
    • Site Suggestions & Comments

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Found 1 result

  1. Hey. New guy here. I just bought a 2013 R180/F115 with 102 freshwater hours on it. I saltwater boat in So Cal, so the first thing I need to do is convert this single battery boat to dual—not counting trolling motor batteries. The manual (complete with schematics) came with the boat. Looks like a Blue Seas 6007 4-position mini switch is a drop in replacement for the on/off switch that is in there now. New switch, add a second battery cable, ACR and a negative distribution point and I should be good to go in the stern. Of course I will need to add a House fuse block in the console along with feed wiring and a circuit breaker. Now about adding the batteries. I fish offshore during the season and fish inshore all year. I use a lot of electronics, so I usually outfit my boats with a pair of group 31 batteries. I also plan on overnighting on this boat under the mooring cover. So there’s 150 pounds in the starboard battery compartment. I can’t live without a GPS enabled and networked trolling motor, so I could possibly add two more 31s in the port compartment—or in the center console if weight distribution becomes an issue. Which brings me to the question: Have any of you loaded up the stern of a R180 with 300# of batteries? How will that affect planing? Any issues with scuppers? I do not currently have trim tabs. Adding the House and trolling motor batts to the console floor is always an option. Next issue is a secondary bilge pump with high water alarm, and a LED indicator to tell me when the primary bilge activates. Anyone know where to get matching chrome thru hulls? Lastly (for now lol) I had to toss those vertical rod holders on the console. They just don’t work for my kind of fishing. I’m putting in 6 vertical holders on each side of the console. So now I have 8 holes to patch where the old rod holders were attached. Be nice to do it right. How do you color match a 2013 R180? Thanks. PS. That transom area is a total PITA to work in. Clearly, the hull was plumbed and wired before the liner was mated to the hull. You need to be an octopus to work back there. Here is the single battery panel, awaiting the drop-in dual battery switch.