Jump to content

Search the Community

Showing results for tags 'R207'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Robalo Boats Forum
    • Cayman Owners
    • Fish Talk
    • Boat Talk
    • Dock Talk
    • Newbies
    • Info Center
  • Site Suggestions & Comments
    • Site Suggestions & Comments

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 17 results

  1. I have a 2014 R207 with factory installed dual batteries and have a question on the battery switch. In the Owner’s manual page 3-2 has the following: If the switch is in the: “OFF” position then only Bilge pump, CO detector and Stereo memory has power. “#1” Position uses only number 1 battery “#2” Position uses only number 2 battery “ALL” Position uses both batteries It continues on to say that: The “#1” position will use battery 1 power but will charge both batteries when engine is running. The “#2” position uses battery 2 they recommend this setting for using power when the engine i
  2. Happy holidays everyone. I added a gemini strapless bimini kit to my R207. Getting rid of the rear support struts really adds space to fish when the bimini is up. Only been offshore a couple of times since I installed them and it works great! Well made and the quality of the SS is better than the factory bimini. Not cheap, but much less than installing a hardtop or arch. So far, very happy with my purchase. Gemini Strapless Bimini Kit Installation Video
  3. I recently took delivery of a new to me 2016 R207 with 108hrs on it. It's a great boat and I'm very happy so far. It stays in a slip and because the weather and wind have been pretty bad the last couple weeks I've only gotten a chance to take it out once. I went down the other day to drop some stuff off on her and I noticed she was sitting a little low. I hopped on and flipped the battery switch on and heard a pump turn on immediately. Then I decided to manually flip the bilge pump on and sure enough it started pumping out quite a bit of water. When I turned the battery on the previous couple
  4. Hi all! I'm taking delivery of a new to me 2016 R207 in a couple weeks. Does anyone have any pics or the electronics setup from inside the helm compartment? I'm trying to see what the buss bars and electronics look like from behind the helm. I want to add some navigation lights and I was curious if there is room for accessories beyond what is standard. I saw there were some Aux switches that didn't seem to be marked with anything.
  5. I have been an engineer for 40 years and I cannot understand this. I have trouble putting fishing rods in the gunnel rod holders so I took them apart. I found that the factory hacksaws the insert down to about 10 inches long on the front set and down to 3 or 4 inches long in the stern. There is plenty of room to leave them long and even a molded fiberglass flange to support the end of the sleeve. There is a high probability of snagging the speaker wires or the LED wires with the fishing rod guides. Besides the damage to the rod guides themselves. Maybe Joe Balo knows the reason!
  6. I have a 2016 r207 and this last weekend notice that the bilge pump is kicking on every 45 minutes - hour and draining the bilge. I cannot locate where the water is coming in at that boat was just sitting at the dock. the dealer told me it is normal to have some water coming into the boat but I have owned a few different boats and the bilges on all those seen to stay dry. anyone else have this problem and what should I check.
  7. I have a 2014 r207. A friend tried to help me get my boat set up after winter. He connected the ground battery wire to the positive post. I corrected that but now i am not getting power to any of the electronics in the helm nor does the bilge work. Motor starts and runs fine as well as motor related gauges. Help!
  8. Does anyone know where i can get my hands on a 2013 R207 Owner's Manual on-line??
  9. I noticed too much water is getting into the bilge on my R207. Found out the storage areas under the chairs drain directly into the bilge (no simple way to redesign that) and that water is leaking into the center storage due to the lack of gaskets around the hinges and the latch (see picture). I plan to put some gasket tape there (2 inch wide by 1/4 thick). Figured I'd ask what others have done before trying the tape.
  10. Just bought a 2013 r207 with a Yamaha 150. I use it in the Northern Chesapeake, Bohemia, Sassafrass, Elk and Susquehanna river areas. I have mostly used it for wakeboarding, skiing and tubing with the family so far but am looking forward to switching over to fishing now that the weather is changing. It does a great job at pulling all 225 lbs of me right out of the water on the wakeboard. We had the ski tow bar installed and it does a great job of keeping the line out of the water. It's also a really convenient grab bar when climbing up the ladder on the stern. I have had a few minor elect
  11. Here is what I have learned, Robalo released an R207 in September with plans to give it a "national price". The R227 was slated for a remodel, presumably because the LOA between the R207 (LOA 20' 7")and R227 (LOA 21' 6") was a mere 11 inches, leaving a 2' 6" gap between the R227 and R247 (LOA 24'). The R227 to receive a "national price" tag also. Well, the 2013s are showing up on boat trader and dealer web pages advertising "all new" and LOAs between 22 and 23 feet, making them better situated between the R227 and R247. The "national price" looks ok too at just under XXX. Be careful though, X
  12. OK OK I know its HULL not HOLE - coffee has not kicked in yet this AM...cant believe I did that and Robalo wont let me fix the title - but anyway... Anyone have success doing this? I am thinking about a Humminbird puck transducer to help with high speed depth tracking issues but the requirement is as follows "Hull must be of single-layer, fiberglass construction and be free of trapped air or voids" Not sure if there is core, kevlar or other matls that would make this fail. Much more attractive alternative that drilling a 1" hold through the bottom of the boat.... Matt
  13. Just Purchased a R207 and I am looking for some information on how to hook my iCom M412 to function off of one of my free switches, but looking under the console there seems to be wires in those spots. So I wnated to see if someone could help me out with this. I also have two batteries, a crossover switch and looks like two busbars. Thanks
  14. http://www.boattest.com/boats/boat_video.aspx?ID=2787
  15. Boattest.com R207 http://www.boattest.com/boats/boat_video.aspx?ID=2787
  16. Boattest.com Captain's Report http://www.boattest.com/boats/boat_video.aspx?ID=2787
  17. Check out the new R207! Enjoy!
×
×
  • Create New...